2-31
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SIP200_SPITX Messages
Error Message %C7600_SIP200_SPIRX-3-STATUS_INTERRUPT: [chars], Global Int status =
[hex]
Explanation
A status interrupt has occurred from the ingress SPI4.2 device.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
C7600_SIP200_SPITX Messages
This section contains SIP 200 SPI4.2 bus egress interface (C7600_SIP200_SPIRX) messages.
C7600_SIP200_SPITX-3
Error Message %C7600_SIP200_SPITX-3-BADDESC: descriptor [hex], tag [hex], global
channel [int]
Explanation
The egress SPI4.2 device on the line card returns a descriptor entry that is corrupted.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-BADPAK: corrupted packet to [chars]
Explanation
The egress SPI4.2 device on the line card is handling a packet that is corrupted. This
condition indicates that an internal software error has occurred. The corrupted packet has been
dropped.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
To Next Page
Loading...
Need help?
General