Cisco III - Supervisor Engine III User Manual

2-312
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
VPNSMIOS Messages
Error Message %VPNSM-6-ACEPKARNGDUP: PKA: A pseudo-random number was generated twice
in succession. [hex][hex]; 0Unrecognized format ‘x%p’ 0Unrecognized format ‘x%p’
idx:[hex]
Explanation
An error has been reported by the firmware
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
VPNSMIOS Messages
This section contains VPNSM crypto connection (VPNSMIOS) messages.
VPNSMIOS-3
Error Message %VPNSMIOS-3-ILLEGALINTERFACE: Traffic matching crypto maps on [chars]
will go through unencrypted. Please reconfigure crypto maps as required by VPN
service module.
Explanation
An attempt was made to apply an encryption (crypto) map set to an interface that is not
a VLAN interface. When this IPsec VPN accelerator is being used, crypto map sets can only be
applied to a VLAN interface that has a proper encryption (crypto) connection to a physical port. The
interface has been disabled. For more information about crypto guidelines, consult the system
configuration manuals.
Recommended Action Remove the crypto map set from the virtual interface. For more details, consult
the configuration guidelines.
Error Message %VPNSMIOS-3-MACEDONNOCCONB2BERR: [chars]no crypto connect is
disallowed
Explanation
The system cannot remove the cryptographic connection when a module-to-module
partner is still active.
Recommended Action Remove the module-to-module configuration before removing the
cryptographic connection.

Cisco III - Supervisor Engine III Specifications

General

Brand	Cisco
Model	III - Supervisor Engine III
Category	Software
Language	English