2-202
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
PISAL2M Messages
Error Message %PISA_FM-5-INSPECT_ALL_ENABLED: [chars] [chars] is applied on [chars]
in [chars] direction.
Explanation
The inspect all feature has been enabled on the specified interface in the input or output
direction. All packets in the specified direction will be routed to the Programmable Intelligent
Services Accelerator (PISA) for inspection.
Recommended Action No action is required. This message is for informational purposes only.
PISAL2M Messages
This section contains Programmable Intelligent Services Accelerator (PISA) Layer 2 Module (L2M)
messages.
PISAL2M-2
Error Message %PISAL2M-2-ERROR: [chars] [chars]:[dec]
Explanation
A software error occurred. The message provides information that might be useful in
troubleshooting.
Recommended Action Copy the error message exactly as it appears, and report it to your technical
support representative.
PISAL2M-3
Error Message %PISAL2M-3-ERROR_STAT: [chars] stat:[dec] in [chars]:[dec]
Explanation
A software error occurred. The message provides information that might be useful in
troubleshooting.
Recommended Action Copy the error message exactly as it appears, and report it to your technical
support representative.
PISAL2M-4
Error Message %PISAL2M-4-PISA_L2_SVI_INCONSISTENCY: Config Inconsistency : Feature
acc at [chars] with [chars] not ADMINDOWN
Explanation
Feature acceleration should be configured on an interface only while its switch virtual
interface (SVI) is in the administratively down state.
Recommended Action Remove the feature acceleration or shut down the SVI and reconfigure.
To Next Page
Loading...
Need help?
General