2-247
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SSP Messages
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
SSP Messages
This section contains State Synchronization Protocol Manager (SSP) messages.
SSP-3
Error Message %SSP-3-DATACREATEFAIL: Creation of required data structures failed.
Explanation
The SSP will not operate properly due to the abnormal initialization of required data
structures.
Recommended Action Reload the device. If the error persists, contact your technical service
representative.
Error Message %SSP-3-EXCEEDMAXDOI: SSP maximum DOI exceeded.
Explanation
The configuration has exceeded the maximum number of SSP clients allowed on this
device at any one time.
Recommended Action Verify your configuration and reduce the number of SSP clients running at the
same time. If a large number of SSP clients is required, contact your technical service representative
for assistance.
Error Message %SSP-3-NOSTART: SSP could not initialize.
Explanation
The SSP process could not successfully initialize. This condition might be caused by
unusual protocol startup times in certain topologies.
Recommended Action Ensure that your IP redundancy mechanism (HSRP) configuration is valid and
that all protocols have started. Try to configure SSP again. If this error recurs, contact your technical
support representative.
Error Message %SSP-3-SRVSOCKCREATEFAIL: SSP socket creation failed.
Explanation
The SSP process could not establish a socket connection with the SSP peer. This
condition is likely to occur because either the device is under extreme load or it is misconfigured.
Recommended Action Verify that the SSP configuration is valid. Configure SSP to use a different port
number. Reduce the load on the device.
To Next Page
Loading...
Need help?
General