Cisco III - Supervisor Engine III User Manual

2-41
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SSC400 Messages
C7600_SSC400 Messages
This section contains Services SPA Carrier Card (C7600_SSC400) messages.
C7600_SSC400-3
Error Message %C7600_SSC400-3-DCM_FAIL: [chars] FPGA module DCM Lock Failure,
status:[hex]
Explanation
One or more of the Digital Clock Managers (DCM) for the data path
field-programmable gate arrays (FPGAs) failed to lock. This indicates a hardware failure.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
Error Message %C7600_SSC400-3-DP_COUNTERS: Failed to create DP counter process.
Explanation
The system was unable to launch a process on bootup to monitor the counters of the data
path field-programmable gate arrays (FPGAs).
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
Error Message %C7600_SSC400-3-DP_ERROR: Bus Error initializing [chars] FPGA, addr:
[hex].
Explanation
This field-programmable gate array (FPGA) could not be initialized due to a bus error.
This condition indicates a hardware failure, possibly due to a failed field-programmable device
(FPD) upgrade.
Recommended Action Enter the show hw-module slot fpd command. If this message recurs, copy the
error message exactly as it appears on the console or in the system log. Research and attempt to
resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.

Cisco III - Supervisor Engine III Specifications

General

Brand	Cisco
Model	III - Supervisor Engine III
Category	Software
Language	English