2-107
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
EARL Messages
EARL-3
Error Message %EARL-3-FABRIC_CONNECTION : Recovering from sequence error detected on
fabric connection.
Explanation
A sequence error was detected by the crossbar and bus fabric interface. This error can
be fatal. Recovery is being attempted.
Recommended Action If this message recurs, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the issue using the tools and utilities provided
at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %EARL-3-RESET_LC: Resetting module in slot [dec]. (Errorcode [dec])
Explanation
The specified module did not respond to a critical message. This condition indicates a
hardware error and might be a transient error only. The system has reset the module to fix the error.
Recommended Action If this message recurs, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the issue using the tools and utilities provided
at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
EARL-4
Error Message %EARL-4-BUS_CONNECTION : Interrupt [chars] occurring in EARL bus
connection.
Explanation
An error interrupt is occurring for the switching bus interface.
Recommended Action Enter the show earl status command on the consoles of the switch supervisor
engine and any DFC-enabled modules. Copy the message exactly as it appears on the console or in
the system log. Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
To Next Page
Loading...
Need help?
General