2-60
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CONST_DIAG Messages
Error Message %CONST_DIAG-3-DIAG_FW_TEST_CARD_DOWN: Failed to disable module [dec]
Explanation
The module could not be powered down after firmware diagnostics failed.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %CONST_DIAG-3-DIAG_FW_TEST_CARD_RESET: Failed to reset module [dec]
Explanation
The module could not be reset after firmware diagnostics failed.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %CONST_DIAG-3-DIAG_TEST_PORT_SKIP: Module [dec] [chars] skipped
multiple ports due to high traffic (Traffic=[dec]%)
Explanation
Online diagnostics did not take place on multiple ports in the specified module because
of high traffic volume.
Recommended Action No action is required.
Error Message %CONST_DIAG-3-DIAG_TEST_SKIP: Module [dec] [chars] skipped due to high
traffic (Traffic=[dec]%)
Explanation
Online diagnostics were skipped on the specified module because of high traffic
volume.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General