TX100 S3 Upgrade and Maintenance Manual 105
7 Hard disk drives
I For information on RAID controllers, please refer to chapter "Expansion
cards and backup units" on page 147.
Safety notes
V CAUTION!
● The hard disk drives must all be marked clearly so that they can be
put back in their original places after an upgrade. If this is not done,
existing data can be lost.
● Do not touch the circuitry on boards or soldered parts. Hold the
metallic areas or the edges of the circuit boards.
● Before removing a hard disk drive, wait for about 30 seconds until the
disk has stopped spinning completely.
● When a hard disk drive is starting up, a resonant noise may be
audible for a short while. This does not indicate a failure.
● Depending on the OS, you can configure the write cache settings for
the hard disk drives. If a power failure should occur while the write
cache is enabled, cached data may be lost.
● When disposing of, transferring, or returning a hard disk drive, wipe
out the data on the drive for your own security.
● Rough handling of hard disk drives may damage the stored data. To
cope with any unexpected problems, always back up important data.
When backing up data to another hard disk drive, you should make
backups on a file or partition basis.
● Handle the device on a shock and vibration free surface.
● Do not use the device in extremely hot or cold locations, or locations
with extreme temperature changes.
● Never attempt to disassemble a hard disk drive.
● For further safety information, please refer to chapter "Important
information" on page 29.
To Next Page
Loading...
Need help?
General