TX100 S3 Upgrade and Maintenance Manual 189
Expansion cards and backup units
9.3.6.5 Installing a replacement FBU
Ê Install the new FBU into the FBU holder as described in section "Preparing
the FBU" on page 175.
Ê Install the FBU holder into the chassis as described in section "Installing the
FBU holder into the chassis" on page 177.
Ê Connect the FBU adapter cable to the TFM as described in section
"Connecting the FBU adapter cable to the TFM" on page 178.
9.3.6.6 Concluding steps
Perform the following procedures to complete the task:
Ê
Check carefully the cable routing and close the cable clamps.
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
Ê If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section "Updating RAID controller
firmware" on page 75.
To Next Page
Loading...
Need help?
General