Fujitsu PRIMERGY TX100 S3 Maintenance Manual

78 Upgrade and Maintenance Manual TX100 S3
Basic software procedures
5.2.5 Enabling replaced components in the system BIOS
When a processor, an expansion card, or a memory module fails, the defective
component will be set to Disabled or Failed in the system BIOS. The server will
then reboot with only the intact hardware components remaining in the system
configuration. After replacing the defective component, it needs to be re-
enabled in the system board BIOS.
Ê Enter the BIOS.
Ê Select the Advanced menu.
Ê Select the status menu of the desired component:
– Processors: CPU Status
I This option is only available for multi-processor systems.
– Memory: Memory Status
– Expansion cards: PCI Status
Ê Reset replaced components to Enable.
Ê Save your changes and exit the BIOS.
I For detailed information on how to access the BIOS and modify settings,
refer to the corresponding BIOS Setup Utility reference manual.
5.2.6 Verifying the system time settings
I This task only applies to Linux environments.
Ê After replacing the system board, ask the system administrator whether the
RTC or UTC time standard is to be used as system time.
I If the system time (RTC) is set to UTC, the SEL (System Event Log)
time stamps may differ from the local time.
Ê Check the system time set in the RTC (Real Clock Time), and if applicable,
correct it in the BIOS.
Ê Enter the BIOS.
Ê Select the Main menu.

Fujitsu PRIMERGY TX100 S3 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3
Category	Server
Language	English