210 Upgrade and Maintenance Manual TX100 S3
Main memory
10.4.3 Removing a memory module
Ê Identify the defective memory slot using the server management software.
Ê Remove the defective memory module as described in section "Removing
memory modules" on page 207.
10.4.4 Installing a memory module
Ê Replace the defective memory module as described in section "Installing
memory modules" on page 204.
10.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page 73.
Ê Enable the replaced memory module(s) as described in section "Enabling
replaced components in the system BIOS" on page 78.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 82.
To Next Page
Loading...
Need help?
General