Fujitsu PRIMERGY TX100 S3 Maintenance Manual

162 Upgrade and Maintenance Manual TX100 S3
Expansion cards and backup units
Ê Remove all external cables from the expansion card to be replaced.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
9.2.3.3 Removing an expansion card
Ê Remove the defective expansion card as described in section "Removing
expansion cards" on page 156.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Mounting expansion card slot
brackets" on page 190.
9.2.3.4 Installing an expansion card
Ê If applicable, install a slot bracket on the new expansion card as described
in section "Mounting expansion card slot brackets" on page 190.
Ê Install the new expansion card as described in section "Installing expansion
cards" on page 150.
9.2.3.5 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "Cabling
overview" on page 322.
9.2.3.6 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page 166.
9.2.3.7 Concluding steps
Perform the following procedures to complete the task:
Ê Check carefully the cable routing and close the cable clamps.
Ê Close the side cover as described in section "Installing the side cover" on
page 58.

Fujitsu PRIMERGY TX100 S3 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3
Category	Server
Language	English