Fujitsu PRIMERGY TX100 S3 Maintenance Manual

290 Upgrade and Maintenance Manual TX100 S3
System board and components
● Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
● For further safety information, please refer to section "Environmental
protection" in the PRIMERGY TX100 S3 Operating Manual.
● Ensure to insert the CMOS battery the with the positive pole
facing up!
14.1.1 Required tools
● Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
● Main steps: tool-less; recommended: tooth pick
14.1.2 Preliminary steps
Before replacing the CMOS battery, perform the following steps:
Ê Shut down the server as described in section "Shutting down the server" on
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting power cord" on page 43.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 61.

Fujitsu PRIMERGY TX100 S3 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3
Category	Server
Language	English