334 Upgrade and Maintenance Manual TX100 S3
Cabling
15.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
15.3 Replacing the front USB cable
15.3.1 Required tools
● Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
● Replacing the power cable: tool-less
15.3.2 Preliminary steps
Before replacing the power cable, perform the following steps:
Ê Shut down the server as described in section "Shutting down the server" on
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting power cord" on page 43.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 61.
To Next Page
Loading...
Need help?
General