Fujitsu PRIMERGY TX100 S3 Maintenance Manual

TX100 S3 Upgrade and Maintenance Manual 303
System board and components
14.2.3.2 Preliminary steps
Before replacing the TPM, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 69.
Ê Shut down the server as described in section "Shutting down the server" on
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting power cord" on page 43.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
Ê Remove the HDD cage as described in section "Removing the HDD cage"
on page 61.
14.2.3.3 Removing the TPM
Ê Remove the TPM as described in section "Removing the TPM" on page 297.
Ê Leave the TPM spacer on the system board when removing the defective
TPM.
14.2.3.4 Re-installing the TPM
Ê The TPM spacer is already present on the system board.
Ê Install the system board as described in section "Installing the system board"
on page 310
Ê Re-install the new TPM as described in section "Installing the TPM" on
page 293.
14.2.3.5 Concluding steps
Perform the following procedures to complete the task:
Ê Install the HDD cage as described in section "Installing the HDD cage" on
page 63
Ê Close the side cover as described in section "Installing the side cover" on
page 58.

Fujitsu PRIMERGY TX100 S3 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3
Category	Server
Language	English