66 Upgrade and Maintenance Manual TX100 S3
Basic hardware procedures
Figure 25: Fastening the screws
Ê Ensure that the noses engage under the guides (see circles) and all screw
holes are matching.
Ê Fasten the four screws (see circles) of the HDD cage.
4.8.1 Concluding steps
Perform the following procedures to complete the task:
Ê Install the HDDs as described in section "Installing 3.5-inch HDDs" on
page 107.
Ê For reconnecting the detached cables to the HDDs refer to "Connecting
power" on page 112.
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
To Next Page
Loading...
Need help?
General