TX100 S3 Upgrade and Maintenance Manual 237
Accessible drives
12.2 Installing accessible drives
12.2.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing accessible drives: tool-less
12.2.2 Preliminary steps
Before installing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 69.
Ê Shut down the server as described in section "Shutting down the server" on
page 42.
Ê Remove the power cord from the cable tie and disconnect it from the system
as described in section "Disconnecting power cord" on page 43.
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section "Removing the side cover" on
page 45.
Ê Remove the optical disk drive as described in section "Removing an optical
disk drive (ODD)" on page 258.
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
Need help?
General