60 Upgrade and Maintenance Manual TX100 S3
Basic hardware procedures
Ê Close the cable tie around the power cord (1) and pull tight (2) to secure the
power cord.
4.6 Switching on the server
V CAUTION!
● Before switching on the server, make sure the side cover is closed. In
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and to satisfy cooling requirements,
the PRIMERGY TX100 S3 server must not run while the side cover
is removed
● Follow the safety instructions in chapter "Important information" on
page 29.
Ê Connect all peripheral cables to the server.
Figure 18: Power button on the front panel
Ê Press the On / Off button to start up the server.
Ê Ensure that the LED in the On / Off button is lit green.
I For more information see "Front panel and external connectors" on
page 273.
I For the 0-Watt device
When the server does not start even if the On / Off button is pressed,
press the push button mains switch on the 0-Watt device one-time (on
the rear of the server). Then press the On / Off button again.
/
To Next Page
Loading...
Need help?
General