Users
The MPX200 supports two types of users:
• Administrative user: To manage the MPX200, you must be in an administrative session. The default
password for the administrator is config.
• Data migration user (miguser): This user session is required to configure migration-related activities.
The default password is migration. For all DSM functions, you must run a miguser session.
Getting started
This section helps you get started using DMS with the MPX200 and the mpx Manager for Data
Migration Services by describing the supported configurations, some best practices recommendations,
and hardware and software setup.
Supported configurations
This section describes the supported topologies and fabrics, and lists the supported fabric and array
types.
Fabric configuration
Figure 87 shows a typical setup for data migration with a dual-fabric high-availability (HA) configuration
with both array controller ports and one port from each MPX200 blade connected to each fabric.
This configuration enables the MPX200 to perform load balancing.
Figure 87 Single and dual blade high-availability setup
.
Table 25 shows the migration rates that can be achieved for a single blade, depending on the
bandwidth capability of the storage array.
Offline Data Migration144
To Next Page
Loading...
Need help?
General