8. In the right pane, click the LUN to be assigned to the data migration appliance (see Figure 127).
Figure 127 Selecting LUNs in Storage Management Utility
.
9. In the Assign Host Access Privileges table, select the DM-Host in the Host WWN - Name list, and
then enter the appropriate, planned LUN ID.
10. To accept and save the LUN assignment, click Map it.
11. Refresh the data migration user interface to see if the LUN assignment is reflected properly and
that the appropriate array entity appears under FC Array. (You may need to click the Refresh
button several times to correctly reflect the changes.)
Assigning LUNs from an MSA1000/1500 array
HPStorage Vendor
MSA 1000/1500 arraysArray Model
Storage Navigator Modular user interfaceLUN Assignment Tool
To assign LUNs:
1. Perform zoning as follows:
a. Connect the Fibre Channel ports of the data migration appliance to a switch where the
storage controller ports are also logged.
b. Using switch management tools, create a zone DM_Host_MSA1000, and then add the
WWPN of the data migration appliance Fibre Channel ports and storage controller ports
in this zone.
c. Save the zoning information and activate the new zoning configuration.
Data migration best practices382
To Next Page
Loading...
Need help?
General