1. Modify the initiator name:
# vi /etc/<initiatorname>.iscsi
2. To configure the initiator and targets, start the iSCSI initiator applet (located in the YaST Control
Center under Network Services), and then set the initiator to start at boot time (Figure 47).
Figure 47 Configure the iSCSI initiator and targets
.
3. Select the Discovered Targets tab and enter the iSCSI target IP address (Figure 48).
Figure 48 Discovered Targets tab
.
MPX200 Multifunction Router 71
To Next Page
Loading...
Need help?
General