To rescan targets in the CLI:
1. Open a miguser session using the following command:
miguser start -p config
2. To rescan for target ports, enter the following command:
target rescan
For example:
MPX200 (admin) #> target rescan
Scanning Target WWPN 00:00:02:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:01:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 00:00:03:00:00:00:00:00
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:11
Target Rescan done
Scanning Target WWPN 50:08:05:f3:00:1a:15:19
Target Rescan done
Target Re-Scan completed
Viewing job details and controlling job actions
DMS allows you to view the details of a configured data migration job and control the job actions
from either the mpx Manager GUI or the CLI.
Viewing job details and controlling job actions in the GUI
The mpx Manager provides a view of the details of data migration jobs. From the detailed view, you
can also control job actions, including pausing, stopping, deleting, resuming, and restarting the job.
To view data migration job details in the GUI:
1. In the mpx Manager left pane, click a migration group to view the status for all jobs belonging
to that specific group.
Offline Data Migration170
To Next Page
Loading...
Need help?
General