set array
Sets the target type of an array to make it behave as either a source, a destination, or both.
Session: miguser
Example:
MPX200 <1> (admin)(miguser) #> set array
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId Symbolic Name Target Type
----- --------------------------------- --------------- -----------
0 20:78:00:c0:ff:d5:9a:05, 00-00-00 HP MSA2012fc-0 Src+Dest
1 50:00:1f:e1:50:0a:e1:49, 82-07-00 HP HSV200-1 Src+Dest
2 50:06:01:60:4b:a0:35:de, 82-03-00 DGC RAID-2 Src+Dest
3 50:00:1f:e1:50:0a:37:18, 00-00-00 HP HSV210-3 Src+Dest
Please select a Target Id from the list above ('q' to quit): 0
Symbolic Name (Max = 128 characters) [HP MSA2012fc-0]
Target Type (1=SrcTarget, 2=DstTarget, 3=Src+Dest 4=None Target) [3 ]
Bandwidth for Migration (0=Array Bandwidth, 50-1600 MBps ) [0 ]
Enable Load Balancing (0=Enable, 1=Disable) [Enabled ]
Array based licensed applied.
All attribute values for that have been changed will now be saved.
Offline Data Migration194
To Next Page
Loading...
Need help?
General