6-12 Range, Digits, Speed, and Filters Models 2500 and 2502 User’s Manual
Filter control
When filtering is being applied to the input signal, the FILT annunciator will be on. The
FILTER key is used to control filtering. Pressing FILTER turns on the FILT annunciator to
indicate that the filter configuration is being applied to the input. Pressing FILTER a sec-
ond time turns the FILT annunciator off to indicate that filtering is turned off.
Figure 6-6
Configure filtering menu tree
Table 6-5
Filter configuration menu
Menu item Description
CONFIGURE FILTERING
AVERAGE-MODE
MOVING
REPEAT
AVERAGE-COUNT
ADVANCED
DISABLE
ENABLE
MEDIAN-RANK
Configure filter.
Select average mode filter.
Moving average.
Repeat average.
Set average filter count (1-100).
Enable/disable advanced filter.
Disable advanced filter.
Enable advance filter.
Select median rank (0 -5).
Advanced
Average
Mode
Average
Count
Median
Rank
Filter
Moving Repeat Disable Enable
Config
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
