Models 2500 and 2502 User’s Manual Digital I/O Port, Output Enable, and Output Configuration 12-9
Remote output configuration
Output configuration commands
Table 12-2 summarizes output configuration commands. These commands include those
to enable and disable the output enable line as well as commands to control output off
states. See Section 17, “OUTPut subsystem” and “SOURce subsystem,” for more
information.
NOTE Output enable and source clear are global and affect both channels
simultaneously.
Table 12-2
Output configuration commands
Command Description
:OUTPut[1]:ENABle <state>
:OUTPut[1]:ENABle:TRIPped?
:SOURce[1]:CLEar
:SOURce[1]:CLEar:AUTO <state>
:SOURce[1]:CLEar:AUTO:MODE <name>
:SOURce2:CLEar
:SOURce2:CLEar:AUTO <state>
:SOURce2:CLEar:AUTO:MODE <name>
Enable/disable output enable (state = ON or OFF).
Query output enable tripped state (1 = tripped).
Turn output source off when in idle state.
Enable/disable auto output off. State = ON (output off after
measurement) or OFF (output stays on).
Auto clear mode. Name = ALWays (every reading; default)
or TCOunt (ON when trigger layer entered; OFF when
leaving trigger layer).
Turn output source off when in idle state.
Enable/disable auto output off. State = ON (output off after
measurement) or OFF (output stays on).
Auto clear mode. Name = ALWays (every reading; default)
or TCOunt (ON when trigger layer entered; OFF when
leaving trigger layer).
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
