Models 2500 and 2502 User’s Manual SCPI Command Reference 17-65
Set delay
NOTE All SOURx:DEL commands are global and affect both simultaneously.
DELay <n>
:SOURce[1]:DELay <n> Manually set source delay
:SOURce2:DELay <n> Manually set source delay
Parameters <n> = 0 to 999.998 Specify delay in seconds
MINimum 0 seconds
MAXimum 999.998 seconds
DEFault 0.001
Query :DELay? Query delay
:DELay? DEFault Query *RST default delay
:DELay? MINimum Query lowest allowable delay
:DELay? MAXimum Query highest allowable delay
Description This command is used to manually set a delay (settling time) for the
source. After the programmed source is turned on, this delay occurs to
allow the source level to settle before a measurement is taken. Note that
this delay is the same for both channels.
Do not confuse this source delay with the trigger delay. The source
delay is part of the device action (SDM cycle) while the trigger delay
occurs before the device action. See Section 10, “Trigger model (front
panel operation),” for more information.
Auto delay can instead be used to automatically set the source delay.
See the next command.
AUTO <b>
:SOURce[1]:DELay:AUTO <b> Enable/disable auto source delay
:SOURce2:DELay:AUTO <b> Enable/disable auto source delay
Parameters <b> = 0 or OFF Disable auto delay
1 or ON Enable auto delay
Query :AUTO? Query state of auto delay
Description These commands are used to enable or disable auto delay. When
enabled, the instrument will automatically select a delay period. *RST
and SYST:PRES default is OFF. Note that this delay is the same for
both channels.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
