17-96 SCPI Command Reference Models 2500 and 2502 User’s Manual
OUTPut <event list>
:ARM[:SEQuence[1]][LAYer[1]][:TCONfigure]:OUTPut <event list>Arm layer event
:TRIGger[:SEQuence[1]][:TCONfigure]:OUTPut <event list> Trigger layer events
Parameters Arm Layer Trigger
<event list> = TRIGger Trigger on exiting trigger layer
NONE Disable arm layer output trigger
Trigger Layer Triggers
<event list> = SOURce Output trigger after source level is set
DELay Output trigger after delay period
SENSe Output Trigger after measurement
NONE Disable trigger layer triggers
NOTE Each event in the list must be separated by a comma (i.e., :arm:output source,
delay, sense).
Query :OUTPut? Query output trigger event(s)
Description This command is used to specify when trigger pulses occur on the spec-
ified output trigger line of the Trigger Link (:OLINe).
Arm Layer Trigger — With TRIGger selected, an output trigger will
occur when exiting the trigger layer. With NONE selected, the arm layer
output trigger is disabled.
Trigger Layer Triggers — You can specify from one to all three events.
Each event in the list must be separated by a comma (,).
The SOURce, DELay and MEASure events refer to the Source-Delay-
Measure (SDM) cycle. This is the Device Action in the Trigger Model.
See Figure 10-7 and Figure 10-8. With SOURce specified, an output
trigger occurs after the source is set. With DELay specified, an output
trigger occurs after the delay period. With MEASure specified, an out-
put trigger occurs after the measurement.
NOTE When disabling triggers, the NONE parameter must be sent alone (i.e., trig:outp
none). If it is listed with any of the other event parameters, NONE will be
ignored.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
