17-78 SCPI Command Reference Models 2500 and 2502 User’s Manual
STATus subsystem
The STATus subsystem is used to control the status registers of the Model 2500. The com-
mands in this subsystem are summarized in Table 17-7.
NOTE These registers and the overall status structure are fully explained in Section 14.
Read event registers
[:EVENt]?
:STATus:MEASurement[:EVENt]? Read Measurement Event Register
:STATus:QUEStionable[:EVENt]? Read Questionable Event Register
:STATus:OPERation[:EVENt]? Read Operation Event Register
Description These query commands are used to read the contents of the status event
registers. After sending one of these commands and addressing the
Model 2500 to talk, a value is sent to the computer. This value indicates
which bits in the appropriate register are set.
Program event enable registers
ENABle <NDN> or <NRf>
:STATus:MEASurement:ENABle <NDN> or <NRf> Program Measurement Event Enable Register
:STATus:QUEStionable:ENABle <NDN> or <NRf> Program Questionable Event Enable Register
:STATus:OPERation:ENABle <NDN> or <NRf> Program Operation Event Enable Register
Parameters <NDN> = #Bxx...x Binary format (each x = 1 or 0)
#Hx Hexadecimal format (x = 0 to FFFF)
#Qx Octal format (x = 0 to 177777)
<NRf> = 0 to 65535 Decimal format
Query :ENABle? Read an enable register
Description These commands are used to program the enable registers of the status
structure. The binary equivalent of the parameter value that is sent deter-
mines which bits in the register gets set. See Section 14 for details.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
