Model 2500 and 2502 User’s Manual Getting Started 1-21
Menu item
1
Description Parameters
CAL
3
TEST
DISPLAY-TESTS
4
KEYS
DISPLAY-PATTERNS
CHAR SET
A/D CTRL
AUTO-ZERO
5
DISABLE
ENABLE
LINE-FREQUENCY
GENERAL
DIGOUT
SERIAL#
TIMESTAMP
NUMBERS
Calibrate Model 2500.
Perform tests on Model 2500.
Test front panel keys and display digits.
Test front panel keys.
Test display pixels and annunciators.
Test special display characters.
Control auto zero, line frequency, and NPLC caching.
Control auto zero.
Disable auto zero.
Enable auto zero.
Set the line frequency.
Select general operations.
Set Digital I/O port bit pattern.
Display serial number, firmware revision, SCPI
version.
Reset timestamp.
Select engineering units or scientific notation display
format.
50 or 60Hz
0-15
YES or NO
ENGR,
SCIENTIFIC
Notes:
1
Top level menu choices indicated in bold. Indentation identifies each lower submenu level.
2
When the remote operation interface selection (GPIB or RS-232) is changed, the Model 2500 performs a power-on reset. To check
or change options of the selected interface, you must re-enter the menu structure.
3
Password is required to unlock calibration. (See Service Manual.)
4
Press EXIT key to cancel test.
5
Disabling auto zero will reduce measurement accuracy.
Table 1-4 (continued)
Main menu
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com