MAN B&W 18.06
Page 5 of 5
MAN Diesel
MAN B&W MC/MCC engines 198 62 388.4
Sensor Point of location
Manoeuvring system
ZV 1103 C Solenoid valve for engine emergency stop
XS/PS 1106 C
Reset shut down at emergency
ZS 1109A/B C Turning gear – disengaged
ZS 1110A/B C Turning gear – engaged
ZS 1111A/B C Main starting valve – blocked
ZS 1112A/B C Main starting valve – in service
ZV 1114 C Slow turning valve
ZS 1116A/B C Start air distribution system – in service
ZS 1117A/B C Start air distribution system – blocked
PS 1118 C Manoeuvring system in Emergency Control
ZS 1121A/B C Activate main starting valves - open
ZS 1122 C
Switch at change-over mechanism - change safety system reset between local telegraph and en-
gine side console
XC 1126 C I/P converter for VIT control (Only engines with VIT)
ZV 1127 C Solenoid valve for control of VIT system in stop or Astern funktionl (Only engines with VIT)
PS 1133 C Cancel of tacho alarm from safety system when Stop is ordered
PS 1134 C Gives signal when »Bridge control«
ZV 1136 C Remote stop solenoid valve
ZV 1137 C Remote start solenoid valve
ZS 1138 C Reversing cylinder Ahead position
ZS 1139 C Reversing cylinder Astern position
ZV 1141 C Solenoid valve for rev.cyl activation, direktion Ahead, during remote control
ZV 1142 C Solenoid valve for rev.cyl activation, direktion Astern, during remote control
PT 1149 Pilot pressure to actuator for V.I.T. system (Only engines with VIT)
E 1180 Electric motor, auxiliary blower
E 1181 Electric motor, turning gear
E 1182 C Actuator for electronic governor
Fuel oil
ZV 8020 Z Fuel oil cut-off at engine inlet (shut down), Germanischer Lloyd only
Cylinder lubricating oil
ZT 8203 C Confirm cylinder lubricator piston movement, cyl/cyl
ZV 8204 C Activate cylinder lubricator, cyl/cyl
Scavenge air
PS 8603 C Scavenge air receiver, auxiliary blower control
Table 18.06.02: Control devices on engine
The control devices mainly include a position switch (ZS) or a position transmitter (ZT) and solenoid valves
(ZV) which are listed in Table 18.06.02 below. The sensor identification codes are listed in Table 18.07.01.
Control Devices