2.31
Maintenance
2
3. Adjust handlebars to desired position. Verify the
wiring harness, brake hose, and throttle cable do not
kink.
NOTE: Verify “FWD” printed on riser faces front of
s
nowmobile
4. Secure the front clamp fasteners first to specification.
Fin
ish by securing the two rear clamp fasteners to the
same torque setting.
5. Reinstall the handlebar cover
if equipped.
Adjustable Riser
Periodically inspect the torque of the upper/lower
handlebar clamp fasteners, and slide fasteners.
Ski/Ski Skag Fasteners
Periodically inspect the ski-to-spindle fasteners for proper
torque.
Inspect ski skags and skag fasteners for abnormal wear
a
nd tear. Replace skags when carbide edge is worn away
or when skag is bent/damaged.
Always use new lock nuts when replacing parts.
Handlebar Clamp Fastener Torque:
A = 14.7 ft-lbs (20 Nm)
Handlebar Clamp Fastener Torque:
A = 15.4 ft-lbs (21 Nm) Apply Loctite® 243™
ROX Slide Fastener Torque:
B = 15 ft-lbs (20 Nm)
Adjuster Cranks: Hand Tight
A = 36 ft-lbs (50 Nm)
B = 6 ft-lbs (8 Nm)
C = 7 ft-lbs (10 Nm)
D = 9 ft-lbs (12 Nm)
SKI STOP (“FRONT” TO SKI TIP)
SKI LOOP/HANDLE
SKI SKAG/CARBIDE
A
B
C
D
To Next Page
Loading...
Need help?
General
