9.34
Chassis
10. Reinstall the lower steering shaft nut. Torque nut to
specification.
11. Reinstall the tie rod boot.
12. Reinstall the bulkhead floor plate.
13. Reinstall the left fender assembly using new rivets.
14. Reinstall the following components:
• Right/left engine compartment door
•Hood
• Exhaust pipe/silencer
• Oil tank/clutch cover assembly
• Airbox assembly
• Engine assembly
• Left side front suspension components
NOTE: Allow the adhesive to cure for 24 hours at 68°
F
(20° C) before placing the snowmobile back into
service.
Right Bulkhead Clip Removal
1. Remove the following components:
• Right/left engine compartment door
•Hood
• Nosepan/bumper
• Exhaust pipe/silencer
• Exhaust silencer bracket
• Oil tank/clutch cover assembly
• Airbox assembly
• Engine assembly
• Bulkhead floor plate
• Right side front suspension components
• Fuel tank (Remove fuel hoses and gasoline from
ta
nk)
2. Drill out the rivets securing the right fender to the
bulkhead and
chassis.
3. Remove the exhaust silencer bracket.
4. Remove the two remaining brace screws and nuts.
Steering Shaft Nut: 22 ft-lbs (30 Nm)
To Next Page
Loading...
Need help?
General
