10.22
Battery and Electrical Systems
Battery Conductance Analyzer
Conductance describes the ability of a battery to conduct
current. A conductance tester functions by sending a low
frequency AC signal through the battery and a portion of
the current response is captured, from this output a
conductance measurement is calculated. Conductance
testing is more accurate than voltage, specific gravity, or
load testing.
Authorized Polaris dealers/distributors are required to
u
se the conductance analyzer when testing 12V Polaris
batteries.
Battery Off Season Storage
Whenever the vehicle is not used for a period of three
months or more, remove the battery from the vehicle,
ensure that it's fully charged, and store it out of the sun in
a cool, dry place. Check battery voltage each month
during storage and recharge as needed to maintain a full
charge.
NOTE: Battery charge can be maintained by using a
Po
laris battery tender charger or by charging once a
month to make up for normal self-discharge. Battery
tenders can be left connected during the storage
period, and will automatically charge the battery if the
voltage drops below a pre-determined point.
Polaris MDX-610P
SPX PN: PU-50296
To Next Page
Loading...
Need help?
General
