2.35
Maintenance
2
ELECTRICAL SYSTEMS
Headlight Bulb Replacement
NOTE: Do not touch the bulb with your fingers. The
grease from body oil will cause a hot spot on the bulb
and cause bulb failure. If you do touch the bulb clean
the bulb with isopropyl alcohol.
1. Remove the hood assembly.
2. Locate the bulb connectors on the head lamp
assembly.
3. Rotate the connector counter-clockwise to remove
th
e bulb.
4. Install a new bulb by holding it in a clean shop rag or
na
pkin.
5. Install the connector into the head lamp and turn
clockw
ise.
6. Reinstall the hood assembly.
Tail Lamp Replacement
The rear tail lamp assembly uses light emitting diodes
(LEDs). LEDs cannot be replaced. The tail lamp assembly
must be replaced if an LED is not functioning.
To Next Page
Loading...
Need help?
General
