EasyManuals Logo
Home>Polaris>Snowmobiles>800 RMK ASSAULT 2011

Polaris 800 RMK ASSAULT 2011 User Manual

Polaris 800 RMK ASSAULT 2011
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #173 background imageLoading...
Page #173 background image
4.9
Cleanfire Fuel Injection
4
Diagnostic Trouble Codes (DTCs)
TROUBLE CODE SPN FMI
P
-
CODE
MIL DESCRIPTION
Throttle Position Sensor Abnormal Rate of
Change
51
10 P0120
ON
TPS signal changes too rapidly to be correct.
Throttle Position Sensor Voltage High 3 P0123 TPS signal is above 4.39 VDC.
Throttle Position Sensor Voltage Low 4 P0122 TPS signal is below 0.7 VDC.
Vehicle Speed Sensor 84 2 P0503 2010-ON Data erratic or intermittent (missing).
Oil Level Switch 98 17 P250F
ON
Oil level is low. Sensor disconnected or oil
le
vel fell below switch level.
Intake Air Temperature Circuit Voltage High
105
3 P0113 Sensor signal is above 4.9 VDC.
Intake Air Temperature Circuit Voltage Low 4 P0112 Sensor signal is below 0.19 VDC.
Barometric Pressure Sensor Voltage High
108
3 P2229 Sensor signal is above 3.23 VDC.
Barometric Pressure Sensor Voltage Low 4 P2228 Sensor signal is below 1.25 VDC.
Engine Coolant Temperature Sensor Voltage
Hi
gh
110
3 P0118 Sensor signal is above 4.8 VDC.
Engine Coolant Temperature Sensor Voltage
Lo
w
4 P0117 Sensor signal is below 0.1 VDC.
Coolant Temperature Too High 16 P0217
Code is set and occurrences accumulated
(cou
nted) in ECU whenever engine
temperature hot lamp is illuminated.
Engine Overheat Shutdown (Misfire) 0 P1217
Code is set and occurrences accumulated
(cou
nted) in ECU whenever ECU enables
engine overheat misfire mode.
Engine Temp. Above Normal 15 P1116
Code is set and occurrences accumulated
(cou
nted) in ECU whenever ECU enables hot
lamp.
Alternator Power Supply 167
3 P1569 Chassis voltage too high.
4 P1568 Chassis voltage too low.
EGT Sensor Circuit Voltage High
173
3 P0546
Sensor signal is above 4.9 VDC for at least 2
minu
tes and the engine has been running at
or above 3000 RPM.
EGT Sensor Circuit Voltage Low 4 P0545
Sensor signal is below 0.06 VDC for at least
2 min
utes and the engine has been running at
or above 3000 RPM.
ECU Memory 628 13 P0601 Checksum / CRC Error
Crankshaft Position Sensor 636
8 P0336
2010-ON
Circuit fault.
2 P0335 Plausibility fault.
Port MAG Injector Circuit 651
5 P0261
ON
OPEN circuit or short to ground. Can be
cau
sed by faulty wiring, injector, stator or
ECU.
3 P0262 Circuit shorted to battery voltage.

Table of Contents

Other manuals for Polaris 800 RMK ASSAULT 2011

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris 800 RMK ASSAULT 2011 and is the answer not in the manual?

Polaris 800 RMK ASSAULT 2011 Specifications

General IconGeneral
BrandPolaris
Model800 RMK ASSAULT 2011
CategorySnowmobiles
LanguageEnglish

Related product manuals