Chapter
359
21
System Setup
Setting Startup
You can select the settings status (startup mode) used at
startup.
The following two modes are available.
Resume: Resume mode
Start with the status at the last shutdown.
Custom: Custom mode
Start with settings saved in non-volatile memory.
You can select the following modes separately for
se
tup data and initial status data.
Factory: Start in factory default state.
User: Start in state conf
igured by the user.
Targets of startup mode settings
You can set the startup mode for each of the following
ta
rgets.
Switcher: Switcher (including DME)
Frame Memory / Clip Player / SL Key Content: Frame
memo
ry, clip player, or SL key
Panel: Control panel
For frame memory, clip player, or SL key, the status of
th
e following settings is the target for restoration.
• Content load status
• Frame memory output channel/clip player output
ch
annel status (recalled content, combined channels,
audio enable/disable).
• Key fill/key source status for SL keys (recalled content)
• Loop, playback start point, and playback stop point
se
ttings
• [Variable Speed] button and playback speed settings
• Content that is not saved in content storage cannot be
resto
red.
• When a frame memory output channel, clip player
ou
tput channel, or key fill/key source for an SL key is
locked, the lock is released and the status is restored.
• To restore the content load status, loading is performed
au
tomatically in the background when rebooting.
During automatic loading, it is not possible to load/save
new content or to freeze/record in frame memory. If the
number of content resources to load is high, loading
may take some time.
Saving and Recalling Setup Data
Changing the switcher or control panel setup data saves
the updated data in RAM.
You can also save the RAM setup data on a computer for
la
ter use.
For details, see “Setup Data File Operations”
(page 336).
When the system is turned on/rebooted, the following
s
etup data is recalled depending on the startup mode.
Resume mode: After power off/reset, the RAM setup data
i
s saved and then recalled when booting.
Custom mode: Setup data (user setup data and factory
def
ault setup data) saved in non-volatile memory is
recalled.
Notes
Load Save
Current setup data
(In resume mode, used to recall the setup data from the last
shutdown)
Save
Power on/reset in
custom mode
Initialize
Factory default setup data
Setup
menu
[Setup
Define]
Setup
menu
[All Clear]
File menu
[Load]
File menu
[Save]
Non-volatile
memory
RAM
User setup data
Non-volatile
memory
User setup data
Storage
To Next Page
Loading...
Need help?
General
