409
Setting a delegation button row
You can assign bus delegation buttons to the delegation
button rows (1st row/2nd row) in an AUX bus control
block.
1
Open the Home > Setup > Panel > Xpt Module > Key
Deleg/AUX Assign menu (19104.33).
2
Select the [AUX] tab.
A list of delegation buttons is shown on the left and a
l
ist of assignable buses is shown on the right.
3
In the list on the left, select the target button number
to set.
4
In the list on the right, select a bus to assign.
5
Press the [Set] button.
To inhibit operation
Select the target button number and set the [AUX Deleg
I
nhibit] button to the on state.
To return the assignment to the defaults
Press the [Default Recall] button, check the message, then
press [OK].
Setting the operation mode of the shift
button
You can set the operation mode of the [SHIFT] button
assigned to the right edge of a delegation button row (1st
row/2nd row) in the AUX bus control block.
1
Open the Home > Setup > Panel > Xpt Module > Key
Deleg/AUX Assign menu (19104.33).
2
Select the [AUX] tab.
3
In the [AUX Shift Mode] group, select an operation
mode.
Hold:
Enable the bus in the shifted state of the
delegation buttons while pressing the shift
button.
Lock: Swi
tch the bus between the shifted state and
unshifted state of the delegation buttons each
time the shift button is pressed.
Setting Buttons and Indicators
Setting the on/off state of cross-point
indicators
Cross-point indicators light up in the logical V/K pair
color linked to the logical V/K pair assigned to buttons on
the 3rd row.
You can disable the cross-point indicators so that they do
not
turn on.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
Set the on/off state of cross-point indicators using the
[Xpt Indicator] button.
On: Li
t
Off: N
ot lit
Setting the color of cross-point buttons
You can set the color of the 3rd row/4th row cross-point
buttons.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
In the [Xpt Button Color] group, select a color.
Logical V/K Pair Color: Li
ght up in the color set for
the logical V/K pair.
For details about the logical V/K pair color, see
“Setting a Logical V/K Pair Color” (page 382).
White: L
ight up white.
Setting the Display
You can set the information that appears on the display in
the cross-point control block/AUX bus control block.
The display items and format can be selected for each of
si
x display modes.
1
Open the Home > Setup > Panel > Xpt Module >
Display Mode menu (19104.34).
2
Display the target switcher bank or AUX bus control
block to set.
To Next Page
Loading...
