Tektronix TG8000 User Manual

ATG7 Analog Test Generator module
ATG7 module
ID TEXT submenu
Use this menu to
edit text that is overlaid on the signal for the SIGNAL and
BARS outputs, and to set the display position of the text. Use the up (▲)or
down (▼) arrow button to scroll through the menu. The following table shows
the ID TEXT submenu.
Figure 3-13: ATG7 module ID TEXT submenu
Status. Sets the blinking mode of the text overlay. Use the left (◄)orright(►)
arro
w button to select one o f the following blink modes, and then press the
ENTER button to confirm the selection.
Ena
ble: Turns on the blinking function of the overlay.
Blink Fast: Sets the overlay to blink at approximately 0.5 second intervals.
Blink Slow: Sets the overlay to blink at approximately 1.0 second intervals.
Disable: Turns off the blinking function of the overlay.
X position. Sets the horizontal position of the text. The position is set as a
p
ercentage of active picture width. Use the left (◄)orright(►) arrow button to
change the position. You can set the value from 0.0% to 100.0% in 1% steps.
TG8000 Multiformat Test Signal Generator User Manual 3–25

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English