Tektronix TG8000 User Manual

Getting started
3. Check that no er
ror messages appear on the LCD display.
4. Use the mainframe UTILITY menu to determine if Option 3G is enabled on
the SDI7 m odul
e. Some of the steps in this procedure depend on whether
the option is enabled or not.
a. Press theMO
DULE button until TG8000 : PRESET is displayed.
b. Press the up (▲)ordown(▼) arrow button to select TG8000 :
UTILITY,an
d then press the ENTER button.
c. Press the up (▲)ordown(▼) arrow button until TG8000 : UTILITY :
OPTIONS EN
ABLED is displayed.
d. The second line of the display indicates the o ption status:
SDI7[slot number] None indicates that Option 3G is not enabled
SDI7[slot number] 3G indicates that Option 3G is enabled
NOTE. If more than one SDI7 module is installed in the mainframe, use the
left (◄)orright(►) arrow button to display the option status of the desired
SDI7 mo
dule.
If Option 3G is not enabled and you have the option key, you can enter the
optio
n key to enable the option. (See page 3-254, To enter the option key
on the SDI7 module.)
e. Press the BACK buttontoreturntothemainframemenu.
1–42 TG8000 Multiformat Test Signal Generator User Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English