Getting started
4. Warm up the inst
rument for 20 minutes.
5. Press the front-panel MODULE button until the HDVG7 main menu shown
below appears
.
6. Press the FORMAT button and use the left (◄)orright(►) arrow button to
select a format, then press ENTER.
7. Press one of the front-panel test signal button (for example COLOR BAR)to
output a signal.
8. Connect the SIGNAL 1 connector to the HDTV waveform monitor using
the 75 Ω BNC cable.
9. Set the waveform monitor to view the signal.
10. Check that the signal appears as expected. For example, if you selected a
color bar signal in step 7, check that the color bar signal appears.
11. Disconnect the BNC cable from the SIGNAL 1 connector, and then connect
theBNCcabletotheSIGNAL 2 connector.
12. Check that the signal appears as expected.
SDI7 mod ule functional
check
Use t
he following procedure to check that the SDI7 Dual Channel SD/HD/3G SDI
Video Generator module is functional.
Required equipment.
3 Gb/s waveform monitor
One 1 m (3 ft) BNC to BNC high-bandwidth cable
Procedure.
1. Install the SDI7 module into the TG8000 mainframe. (See page 1-11.)
2. Power on the TG8000 mainframe by connecting it to the power source. The
initialization of all the installed modules is executed.
TG8000 Multiformat Test Signal Generator User Manual 1–41
To Next Page
Loading...
Need help?
General
