DS1067-062C 18 LBT20063
2 SYSTEM COMMISSIONING
This chapter illustrates how to arm and disarm the system totally or partially using the keypads and the electronic and
proximity keys.
It also illustrates how to clear alarm indications and how to use the direct function keys (fire, emergency, silent panic).
IMPORTANT! Users and keys must have been previously acquired, configured and enabled to arm and disarm the
system and to clear the alarms, as explained in paragraph 5.6 Enabling and disabling.
2.1 ARMING PROCEDURE
The arm system may be armed in various manners, some of which are not EN50131 compliant.
EN50131 compliant modes are: arming from keypad, arming with electronic or proximity key, arming by timed programmer
or arming from a specialised input using a mechanical key.
The following modes are not EN50131 compliant: remote arming, arming using GSM and DTMF commands, arming using
a remote control.
The authorisation codes which must be used with keypads are described in paragraph 5.1 System access codes.
It is possible to arm the entire system, only some zones or one or more areas, if the latter are programmed. Areas allow
operating on a subset of zones at the same time without needing to select them each time.
The user or key must have been assigned to the zone or area during programming in order to operate it.
2.2 ARMING FROM 1067/022 KEYPAD
2.2.1 Total arming (system with zones only)
Proceed as follows to arm the entire alarm system if no areas are defined:
1) Enter < Master / User code / Installer / Tech. Manager > and press
.
2) The keypad will beep. Press
to exit without arming. The status LED will light up
after 5 seconds (fixed if all zones are armed, blinking if some zones are not armed).
Press again
if you do not want to wait for 5 seconds.
3) If programmed or if the system is EN50131 grade 3 compliant, the keypad will sound
long beeps initially followed by short beeps for the last 10 seconds.
4) The display will go back to standard view automatically after one minute. Press
to go to standard view immediately.
IMPORTANT! The user will arm only the assigned zones and not necessarily all the zones even with this procedure.
2.2.2 Total arming (system with areas and zones)
Proceed as follows to arm the entire alarm system if areas are defined:
1) Enter < Master / User code / Installer / Tech. Manager > and press
.
2) Enter
or on the keypad. The procedure will continue as for zones only if you
press
. If you press :
3) The keypad will beep. Press
to exit without arming. The status LED will light up
after 5 seconds (fixed if all zones or areas are armed, blinking if some zones or areas
are not armed) and all the areas will appear on the display. Press
again if you do
not want to wait for 5 seconds.
4) If programmed or if the system is EN50131 compliant, the keypad will sound long
beeps initially followed by short beeps for the last 10 seconds.
5) The display will go back to standard view automatically after one minute. Press
to go to standard view immediately.
IMPORTANT! The user will arm only the assigned areas and not necessarily all the areas even with this procedure.
ARM
□□□□••••••••••••
EXECUTED
■■■■••••••••••••
1)AREAS
2)ZONES
ARM
□□••
EXECUTED
■■••
To Next Page
Loading...
Need help?
General
