urmet domus 1067 - Detector Jamming Alarm

DS1067-062C 50 LBT20063
4.2.10 Detector jamming alarm
Monitoring of devices provided with fault output can be implemented in combination on control panels.
This is generated
when...
• If one or more customised jamming inputs are open.
It activates...
• The programmed detector fault outputs which have at least one zone in common with the input
which generated the event (with zone armed).
• The dialler to send the respective alarm message (if programmed) in form of numeric code,
vocal call or modem communication.
It is stored...
• In the Diagnose Log and in the fault and anomaly memory.
It is indicated...
• On fault LED of keypads which have at least one zone in common with the input which
generated the event.
• On readers which have at least one zone in common with the input which generated the event.
After having solved
the problem, the
control panel...
• Stores end of fault in the Diagnose Log.
• Deactivates the programmed fault detector outputs.
4.2.11 Detector fault alarm
Monitoring of devices provided with fault output can be implemented in combination on control panels.
This is generated
when...
• If one or more customised detector fault inputs are open
It activates...
• The programmed detector fault outputs which have at least one zone in common with the input
which generated the event (with zone armed).
• The dialler to send the respective alarm message (if programmed) in form of numeric code,
vocal call or modem communication.
It is stored...
• In the Diagnose Log and in the fault and anomaly memory.
It is indicated...
• On fault LED of keypads which have at least one zone in common with the input which
generated the event.
• On readers which have at least one zone in common with the input which generated the event.
After having solved
the problem, the
control panel...
• Stores end of fault in the Diagnose Log.
• Deactivates the programmed fault detector outputs.
4.2.12 Faulty siren alarm
Monitoring of devices provided with fault output can be implemented in combination on control panels.
This is generated
when...
• One or more customised siren fault inputs are open
It activates...
• The programmed system fault outputs which have at least one zone in common with the input
which generated the event.
• The dialler to send the respective alarm message (if programmed) in form of numeric code,
vocal call or modem communication.
It is stored...
• In the Diagnose Log and in the fault and anomaly memory.
It is indicated...
• On fault LED of keypads which have at least one zone in common with the input which
generated the event.
• On readers which have at least one zone in common with the input which generated the event.
After having solved
the problem, the
control panel...
• Stores end of fault in the Diagnose Log.
• Deactivates the programmed failure outputs.