DS1067-062C 81 LBT20063
7.4 SMS TEXT MESSAGE
IMPORTANT! SMS text alarm notification is not EN50131 compliant and will cancel the compliance of the entire
burglar alarm system.
1067/024, 1067/032A and 1067/052A control panels can send text messages to the programmed telephone numbers
when the following events occur:
• Burglar alarm
• Technological type 1 event
• Technological type 2 event
• Technological type 3 event
• Fire indication
• System/zone arming
*
• System/zone disarming
*
• Tamper
• Notices (SIM expiry)
*) The SMS text message can be up to 40 characters long, except for the arming/disarming messages which are only
24 long because the numbers of the concerned zones are added to the message.
All SMS text messages are empty by default.
The GSM module must be installed in the control panel to send SMS text messages.
Events
SMS generation for control panels
with SW versions earlier than 1.03
SMS generation for control panels from SW version 1.03
USER SMS USER SMS Automated message from Control Panel
Burglar alarm: SMS programmed by user SMS programmed by user In <xxx> : <Input name>
Technological
type 1 event:
SMS programmed by user
SMS programmed by user U <yy> : <Output name>
Technological
type 2 event:
SMS programmed by user
SMS programmed by user U <yy> : <Output name>
Technological
type 3 event:
SMS programmed by user
SMS programmed by user U <yy> : <Output name>
SMS programmed by user SMS programmed by user In <xxx> : <Input name> Fire indication:
SMS programmed by user
SMS programmed by user TS <zz> : <Keypad name>
System/partition
arming:
SMS programmed by user
SMS programmed by user < partition/s arming >
System/partition
disarming:
SMS programmed by user
SMS programmed by user < partition/s disarming >
SMS programmed by user SMS programmed by user In <xxx> : <Input name>
SMS programmed by user SMS programmed by user TS <zz> : <Keypad name>
SMS programmed by user SMS programmed by user ER <zz> : <Expansion name >
SMS programmed by user SMS programmed by user AS <zz> : <Supplemental power supply
name>
SMS programmed by user SMS programmed by user LT <zz> : <Reader name>
Tamper:
SMS programmed by user
SMS programmed by user EW <zz> : <Radio expansion name>
Where
xxx:
Logic input number
yy:
Logic output number
zz:
Device number (keypad / reader / expansion / radio expansion / supplemental power supply)