DS1067-062C 87 LBT20063
9 SYSTEM TEST
9.1 PERIODICAL TESTS
It is advisable to check perfect operation of the burglar alarm system regularly.
The main tests are:
• Input test
• Output test
• Control panel battery test
• Vocal call test
• Alarm receiving centre test (if present)
• GSM test (if present)
• Radio device test
• Environmental listening test
ADVICE: Test the 1067/024, 1067/032A or 1067/052A before prolonged absences, for example before the
summer holidays.
9.1.1 Input test
Proceed as follows to test that the inputs work perfectly:
1) Enter <Master / Installer code>, press
and then .
2) Press
repeatedly until TEST appears.
3) Press
.
4) Press
.
5) Trip all system detectors (e.g. by passing in front of the volumetric detectors and
opening doors with magnetic contacts). The input LED on the keypad will be
activated whenever a detector is activated. Press
at the end.
6) Press
.
7) Press
to view the list of all the inputs which were tripped during the test.
8) Press and then .
9) Press
to view the list of all inputs which did not change. The list should be empty
if all inputs were tripped during the test and they all opened and closed again correctly.
Otherwise, the list will contain the inputs which were either not tripped or did not
respond correctly.
10) Press
repeatedly to exit from the menu.
UT00: MASTER
SYSTEM STATUS
UT01:MASTER
TEST
TEST
TEST INPUTS
TEST INPUTS
IN PROGRESS...
TEST INPUTS
TEST RESULT
TEST RESULT
TEST INPUT OK
TEST RESULT
TEST INPUT OK
To Next Page
Loading...
Need help?
General
