DS1067-062C 29 LBT20063
2.8.3 Partial disarming (system with zones only)
Proceed as follows to arm the entire alarm system partially if no areas are defined:
1) Enter < Master / User code / Installer / Tech. Manager > and press .
2) The keypad will beep. Press
to exit without disarming. The following will appear
on the display:
3) Enter the number of the zones to be disarmed on the keypad: the respective squares will
become empty.
4) After 5 seconds, the LED will switch off and the squares will become empty indicating
that the zones have been disarmed. The following will appear on the display.
5) The display will go back to standard view automatically after one minute. Press to
go to standard view immediately.
IMPORTANT! The user will disarm only the assigned zones and not necessarily all the zones even with this
procedure.
2.8.4 Partial disarming (system with areas and zones)
Proceed as follows to arm the entire alarm system if areas are defined:
1) Enter < Master / User code / Installer / Tech. Manager > and press .
2) Press T1 for areas or T4 for zones. Press T1 (i.e. areas) An empty square will appear
for each programmed area which is not armed assigned to the keypad and code. Full
squares indicate that the area is armed. Half-full squares indicate that the area is only
partially armed.
3) The keypad will beep. Press
to exit without disarming.
4) Press the function keys (T1, T2, T3 and T4) positioned under the areas to be disarmed.
5) After 5 seconds, the status LED will switch off and the squares will become empty
indicating that the areas have been disarmed. The following will appear on the display:
6) Press
if you do not want to wait for 5 seconds.
IMPORTANT! The user will disarm only the assigned areas and not necessarily all the areas even with this
procedure.
7) If T4 was pressed, the following will appear on the display:
8) Enter the number of the zones to be disarmed on the keypad: the respective squares will
become empty.
IMPORTANT! Simply enter the number directly if nine or fewer zones have been programmed. If more than nine
zones have been programmed, always enter two digits to select the zones , including for numbers from 1 to 9 (1 =
01, 2 = 02 etc.). ).
IMPORTANT! Simply enter the number directly if nine or fewer zones have been programmed. If more than nine
zones have been programmed, always enter two digits to select the zones , including for numbers from 1 to 9
(1 = 01, 2 = 02 etc.).
To Next Page
Loading...
Need help?
General
