DS1067-062C 60 LBT20063
5.1.2 Code change
Each user can change their access code freely.
Proceed as follows to change the code:
1) Enter <Master / User / Installer / Technical Manager code>, press
and then .
2) Press
repeatedly until SETTINGS appears.
3) Press
and then several times until CHANGE CODE appears.
4) Press .
5) Enter the new code, from four to six digits, and press .
IMPORTANT! Trough the use of the web server only 6-digit codes are allowed.
IMPORTANT! Any access code shorter than six digits will cancel EN50131 grade 3 compliance of the entire
burglar alarm system.
If there are no other limiting factors, five or six digit access codes allow EN50131 grade 2 compliance.
Four digit codes will cancel EN50131 compliance.
6) Enter the new code and press to confirm.
7) Press
repeatedly to exit from the menu.
UT02:...
SYSTEM STATUS
UT02:...
SETTINGS
SETTINGS
CHANGE CODE
CHANGE CODE
NEW: ------
CHANGE CODE
CONFIRM: ------
1067/052A
12/01/2014 10:10
To Next Page
Loading...
Need help?
General
