SIP User's Manual 104 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
From:
<sip:ContactUser@HostName>;tag=1c1397576231
To: <sip: ContactUser@HostName >
Call-ID: 1397568957261200022256@10.33.37.78
CSeq: 1 REGISTER
Contact:
<sip:ContactUser@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-Gateway-MP-118
FXS_FXO/v.5.40A.008.002
Content-Length: 0
Notes:
 The Trunk Group account registration is not effected by the
parameter IsRegisterNeeded.
 If registration to an IP Group(s) fails for all the accounts defined
in this table for a specific Hunt Group, and if this Group
includes all the channels in the , the Hunt Group is set to Out-
Of-Service if the parameter OOSOnRegistrationFail is set to 1
(refer to ''Proxy & Registration Parameters'' on page 94).
Contact User
[Account_ContactUser]
Defines the AOR user name. It appears in REGISTER From/To
headers as ContactUser@HostName, and in INVITE/200 OK
Contact headers as ContactUser@<device's IP address>. If not
configured, the 'Contact User' parameter from the 'IP Group Table'
page is used instead.
Note: If registration fails, then the user part in the INVITE Contact
header contains the source party number.
Application Type
[Account_ApplicationType]
Note: This parameter is not applicable.
3.3.4.4 Coders and Profile Definitions
The Coders And Profile Definitions submenu includes the following page items:
îš„ Coders (refer to ''Configuring Coders'' on page 105)
îš„ Cod
er Group Settings (refer to ''Configuring Coder Groups'' on page 107)
îš„ Tel Profile Se
ttings (refer to ''Configuring Tel Profiles'' on page 108)
îš„ IP Profile Settings (refe
r to ''Configuring IP Profiles'' on page 110)
Implementin
g the device's Profile features, provides the device with high-level adaptation
when connected to a variety of equipment (at both Tel and IP sides) and protocols, each of
which requires different system behavior.
You can assign different Profiles (behavior) per call, using the call routing tables:
îš„ 'Tel to IP Routing' page (refer to ''Configuring the Tel to IP Routing Table'' on page
131)
îš„ 'IP to Hunt Group Routing'
page (refer to ''Configuring the IP to Trunk Group Routing''
on page 135)
In addition, you ca
n associate different Profiles per the device's channels.
To Next Page
Loading...
Need help?
General
