SIP User's Manual 232 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
[LogoWidth]
Width (in pixels) of the logo image that you want displayed in the Web
GUI.
The range is 0 to 199. The default value is 145 (which is the width of
AudioCodes’ displayed logo).
Notes:
 The optimal setting depends on the screen resolution settings.
 If the width of the loaded image is greater than the permissible
maximum value, the device automatically resizes the image to the
default width size.
 The height is limited to 24 pixels.
[LogoFileName]
Name of the image file that you want to load to the device for being
displayed in the Web GUI's title bar (instead of AudioCodes' logo).
The file name can be up to 47 characters. The default is AudioCodes’
logo file.
Notes:
 The image file type must be GIF, PNG, JPG, or JPEG.
 The size of the image file can be up to 64 Kbytes.
6.2.3 Telnet Parameters
The Telnet parameters are described in the table below.
Table 6-13: Telnet Parameters
Parameter Description
Web: Embedded Telnet Server
EMS: Server Enable
[TelnetServerEnable]
Enables or disables the device's embedded Telnet server. Telnet is
disabled by default for security.
 [0] Disable (default)
 [1] Enable Unsecured
 [2] Enable Secured (SSL)
Note: Only the primary Web User Account (which has Security
Administration access level) can access the device using Telnet
(refer to ''Configuring the Web User Accounts'' on page 73).
Web: Telnet Server TCP Port
EMS: Server Port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Web: Telnet Server Idle
Timeout
EMS: Server Idle Disconnect
[TelnetServerIdleDisconnect]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default value is 0.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: SSH Server Enable
[SSHServerEnable]
Enables or disables the embedded Secure Shell (SSH) server.
 [0] Disable (default)
 [1] Enable
Web/EMS: SSH Server Port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. The default port is 22.
To Next Page
Loading...
Need help?
General
