SIP User's Manual 150 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Phone Number
[TrunkGroup_FirstPhoneNumber]
The telephone number that is assigned to the channel. For a
range of channels, enter only the first telephone number.
Subsequent channels are assigned the next consecutive
telephone number. For example, if you enter 400 for channels
1 to 4, then channel 1 is assigned phone number 400, channel
2 is assigned phone number 401, and so on.
These numbers are also used for channel allocation for IP-to-
Tel calls if the Hunt Group’s ‘Channel Select Mode’ is set to
‘By Dest Phone Number’.
Note: If the this field includes alphabetical characters and the
phone number is defined for a range of channels (e.g., 1-4),
then the phone number must end with a number (e.g., 'user1').
Hunt Group ID
[TrunkGroup_TrunkGroupNum]
The Hunt Group ID (1-99) assigned to the corresponding
channels. The same Hunt Group ID can be assigned to more
than one group of channels. The Hunt Group ID is used to
define a group of common channel behavior that are used for
routing IP-to-Tel calls. If an IP-to-Tel call is assigned to a Hunt
Group, the call is routed to the channel(s) pertaining to that
Hunt Group ID.
Notes:
 Once you have defined a Hunt Group, you must configure
the parameter PSTNPrefix ('IP to Hunt Group Routing'
table) to assign incoming IP calls to the appropriate Hunt
Group. If you do not configure this table, calls cannot be
established.
 You can define the method for which new calls are
assigned to channels within the Hunt Groups, using the
parameter TrunkGroupSettings.
Profile ID
[TrunkGroup_ProfileId]
The Tel Profile ID assigned to the channels.
Note: For configuring Tel Profiles, refer to the parameter
TelProfile.
3.3.4.11 Hunt Group
The Hunt Group submenu allows you to configure groups of channels called Hunt Groups.
This submenu includes the following page item:
îš„ Hunt Group Settings (refer to ''Configuring the Trunk Group Settings'' on page 150)
3.3.4.11.1 Configuring Hunt Group Settings
The 'Hunt Group Settings' page allows you to configure up to 99 Hunt Group IDs. Hunt
Groups are assigned to channels in the ‘Endpoint Phone Number Table’ page (refer to
Configuring the Endpoint Phone Numbers on page 149). Th
e 'Hunt Group Settings' page is
mainly used to select the method for which IP-to-Tel calls are assigned to channels within
each Hunt Group. If no method is selected (for a specific Hunt Group), the setting of the
global parameter ChannelSelectMode in the 'SIP General Parameters' page (refer to
''Configuring SIP General Parameters'' on page 92) appli
es. In addition, this page also
defines the method for registering Hunt Groups to selected Serving IP Group IDs (if
defined). You can add up to 24 entries in this table.
To Next Page
Loading...
Need help?
General
