Version 5.8 91 September 2009
SIP User's Manual 3. Web-Based Management
3.3.4 Protocol Configuration
The Protocol Configuration menu allows you to configure the device's SIP parameters
and contains the following submenus:
îš„ Applications Enabling (refer to Enabling Applications on page 91)
îš„ Protocol Defi
nition (refer to ''Protocol Definition'' on page 91)
îš„ Proxies/IpG
roups/Registration (refer to ''Proxies, IP Groups, and Registration'' on
page 93)
îš„ Cod
ers And Profile Definitions (refer to ''Coders and Profile Definitions'' on page 104)
îš„ SIP Advanced Paramete
rs (refer to ''SIP Advanced Parameters'' on page 112)
îš„ SAS (refer to SAS Parameters
on page 120)
îš„ Manipul
ation Tables (refer to ''Manipulation Tables'' on page 124)
îš„ Routin
g Tables (refer to ''Routing Tables'' on page 129)
îš„ Endpoint Settings (refe
r to Endpoint Settings on page 141)
îš„ Endpoint Nu
mber (refer to Configuring Endpoint Phone Numbers on page 149)
îš„ Hunt G
roup (refer to ''Trunk Groups'' on page 150)
3.3.4.1 Enabling Applications
The 'Applications Enabling' page allows you to enable the SAS application.
Note: For enabling the SAS application, a device reset is required.
¾ To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > Protocol Configuration
menu > Applications Enabling page item).
Figure 3-57: Applications Enabling Page
2. Save the changes to the device's flash memory and reset the device (refer to ''Saving
Configuration'' on page 167).
To Next Page
Loading...
Need help?
General
